Handel bars

Original handle bars and clutch cable off a 2009 Harley Electra Glide Classic

Set of bikemaster bar risers for 7/8" bars in black

Been sitting for a while, chrome is pitted a bit

I have take off parts for sale belong to a 2010 HD Ultra Classic, stock air intake 96 cu , exhaust , lower forks , mirrors , stock levers , 17 and 16 inch wheels, fairing speakers , antenna whips, fuel cap , all stock lighting , front fender trim , stock handle bar controls, floor board inserts .Clearing out garage, make an offer if you need any of these parts.

I have three sets of bag rails fits a 1991 Electra Glide - $ 100 2007 street Glide - $50 , some scratches 2010 Electra Glide - 150 2010 Harley Davidson Ultra Chrome passenger grave bars - $75 And I have a lot of take off parts to fit a 2009 - 2012 Ultra classic.

Honda accesories low sissy bar with back pad black color chrome sissy bar . Was never installed still in box. . Retails around 278.35 plus tax.Located in clarenville. Back rest can be used with or without back pad no holes in sissy bar , pad clamps on to it. Instruction for installation included. Call1709425 0685

Cobra FI2000 in line computer user friendly snap in place unit - takes care of deceleration back-firing and increases HP. - when you add on non-stock pipes and breathers. It done the job well on the bike but my bike was difficult to start with it installed. The settings are stock and can be adjusted but I found it difficult dealing with Cobra Customer Service and technical department. So I removed from the bike and now making an appointment with Harley in St.John's to tune my bike. I had installed a larger breather and Vance Hines pipes - with this installed I had backfiring.......the unit to care of this easily but it took up to 5 attempts to start my bike. The unit may need retuning.........of which I have no patience for it. These selling for up to $500 on the internet. I paid over $350.00 + shipping / Handling. This unit would fit Harley Sporters from 2012 / 2015......but double check just in case. Make me an offer ..... Any questions drop me a line BTW - took it off today bike started first attempt.

Clip ons and bar ends from a 2004 Suzuki SV650S. They were removed to install a handlebar kit. May fit other bikes. 48mm when fully clamped.